Engineering Graphics

Syllabus

Module 1: (15 hours)

Introduction; drawing instruments and their uses; lines, lettering and dimensioning; geometrical construction; constructions of plain, diagonal and vernier scales; orthographic projection—first and third angle projections; orthographic projection of points on principal, profile, and auxiliary planes

Module 2: (17 hours)

Orthographic projection of straight line in simple and oblique positions; application of orthographic projection of line; orthographic projection of planes in simple and oblique position on principal and profile planes; orthographic projection of lines and planes on auxiliary planes.

Module 3: (20 hours)

Orthographic projection of solids in simple and oblique positions on principal and profile planes; orthographic projections of solids in oblique position using auxiliary plane method; orthographic projection of spheres; orthographic projection of solids in section; development of surfaces of solids; method of isometric projection.

References:

1. N. D. Bhatt, Engineering Drawing, 53rd ed. Anand, India: Charotar Publishing House, 2016.
2. Basant Agrawal and C M Agrawal, Engineering Drawing, 2nd ed. New Delhi, India: McGraw Hill Education (India), 2014.